Tech Support Guy banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
9,629 Posts
Discussion Starter · #1 ·
Would like to set up a Mesh network around my neighborhood using several modified WRT54G's. I have several cake pan antennas (24db gain), 25 RF2365 2.4ghz low noise 20db amplifiers, a few 500mw signal boosters, and a 15db gain omni RV antenna.

What do I need to do to get the WRT54G's to mesh? Do I need to install OpenWrt, or can it be done with Sveasoft firmware?
 

· Registered
Joined
·
1,246 Posts
I'd say openwrt is the best for this application, I'll have to check my config to see if the Sveasoft firmware can act as a repeater.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top