Tech Support Guy banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I was running Win95 on my computer, P133, ASUS P/I 55T2P4 Award Bios 4.51PG, BIOS ver 401A0-0109 ChipSet 82430HX. I have a WD 2 GIG Hard Drive and 64 Meg of DRam and 512 Meg of L2 Cache.

Iwa getting lots of FATAL ERRORS and having to reboot alot. It was almost impossible to open any programs. I was not aware that were any disk compession or memory caching utilities running on this computer.

I ran format C: from a Norton Rescue Disk that I had made several months ago. I also ran FDISK, deleted the Primary DOS partition, which was the only partition on the drive.

Then I started to reinstall Windows95 (ver 4.00.950) this is an OEM version. I booted with a CD Rom install disk in the A drive, Typed SETUP, setup initialized and then scheck the computer. No faults found. I selected ENTER to continue the installation. I the got a message that said "setup has found a compressed volume or a disk-cache utility on your computer." It goes on to say quit setup get rid on compression software and/or disk cache utility.

I select ESC to comtinue setup. I get the Windows Setup Screen. I select CONTINUE and the computer shows a load of SETUP WIZZARD. The next screen I am asked to accept the license agreement. I select I AGREE/YES. At this point the computer freezes/locksup. I have to push the RESET or OFF buttons to get going again.

So there must be a compression program running or a disk caching utility operating. How do I check to see if either of these things are there? How do I get rid of them?

George. [email protected]
 

·
Registered
Joined
·
45,855 Posts
Did you fdisk and delete the existing partitions before repartitioning and then formatting? I think, properly done, it should start you with a clean slate.

http://www.computerhope.com/sfdisk3.htm

http://home.socal.rr.com/chansen/fdisk.htm

Also, you might be able to tell if the Doublespace drive compression is installed by running the command:

mem /c /p

from a c:\> prompt. I believe doublespace should be listed as a module if it is installed.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top