Please click the link below for your operating system to download the TSG SysInfo Utility. Click on "Save File" then double-click the file to run it. Copy and paste the report in your initial post. Windows 7 and later (downloads a file named tsginfo.exe) | Windows XP (downloads a file named SysInfo.exe)

Windows wont load after swapping drives

695 Views 1 Reply 2 Participants Last post by crjdriver, Feb 20, 2017

Riva96

Discussion Starter · Feb 19, 2017

I recently cloned my HDD to my SSD and swapped SATA ports so it would boot from the SSD. The computer gives me a black screen after the windows logo shows up. However if i switch the ports back to where they originally were it works fine. Thanks in advance

Save

Status: Not open for further replies.

1 - 2 of 2 Posts

crjdriver

· #2 · Feb 20, 2017

In order to help you, you are going to have to provide a LOT more info. Post your exact system specs along with the exact ssd you installed.
How exactly did you clone the drive? What software was used?

You did not by chance attempt to restart with both drives still connected did you?

Save

1 - 2 of 2 Posts

Status: Not open for further replies.

Top Contributors this Month