Tech Support Guy banner
1 - 9 of 9 Posts

· Registered
Joined
·
1,309 Posts
Discussion Starter · #1 ·
If you happened to catch the news 2 days ago about a helicopter that was hit by an RPG near Fallulah(sp?), that was one of my helos. The crew escaped with non-life threatening injuries. I'll fill you in with the story later.

PaveFE
 

· Registered
Joined
·
27,156 Posts
Glad to hear they survived :)

Keep up the good work.
 

· Registered
Joined
·
2,538 Posts
PaveFE,
Tell the crew that I'm praying for their quick recovery. And for all of you over there covering for our butts over here, I say THANK YOU! :up:
 

· Always remembered in our hearts
Joined
·
82,265 Posts
Pave: I'm glad the men are ok! :up: My prayers remain with all of the troops stationed there! Take care. angel
 

· Registered
Joined
·
1,309 Posts
Discussion Starter · #7 ·
Here's the deal in a nutshell:

2 Ship at 200 feet on approach to an LZ in Iraq.
Flew over some bad guys who shot 3 RPG's at them.
The first 2 missed, but the third hit Chalk lead in the cockpit, taking out part of the lower instrument panel, throttle quadrant, and overhead instrument panel.
It blew the helmet off of the co-pilot (left seat), dislocated the shoulder of the pilot (right seat), and caused some facial injuries to the Flight Engineer in the center seat.
No injuries (that I know of) to the F.E. and the 2 gunners in the backend.
The pilot continued the approach (with a dislocated shoulder) and landed safely. They had to shut it down by using the overhead cables in the cabin, since there was no throttle quadrant. They all got out and went to Chalk 2 and took off with no further incident. The only serious injury was the guy in the center seat, they had to operate on his eyes. Not sure if both eyes are ok, or if 1 is ok and the other they're not so sure about.
In the end, those guys are #1 in my book for landing a helo safely after taking an RPG through the cockpit.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top