Tech Support Guy banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I have an Iomega 120GB fire wire/usb external hdd using O/S xp home + xp proffessional. It was working fine, i have 2 computers and have been able to use it on both working fine. Usually it just does plug-n-play when i plug it in with usb and brings up the folder for the drive, but today i was sorting some files on it and then i switched it off. A while later i plugged it into my computer and it brought up its usual message "Plugging hi-speed usb device into non-hi-speed usb hub click this message to fix", but this time the hard drive did not show up in my computer and locked up my computer until i took it out of the usb port. So i went to device manager and plugged it in again it now comes up as a usb device instead of a hard drive which it usually comes up as. I tried reinstalling the driver off the disk that came with it but this had no effect . Please help, thanks

Bob Mac
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top