Tech Support Guy banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Trying to investigate Time to Ready from a standby (also called S3 time).

The question I have is why when you go from a Standby to Ready, the time it takes for the 1st and/or 2nd pass of this measurement (from when the power button is pressed till when the windows taskbar appears) is usually longer on the 1st & 2nd runs compared to the later runs. I know this involves paging data from the disc, which may need to be reread during those first few attempts. I am looking for any good documentation that explains this in detail. Would appreciate any pointers as to where to look.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top