Please click the link below for your operating system to download the TSG SysInfo Utility. Click on "Save File" then double-click the file to run it. Copy and paste the report in your initial post. Windows 7 and later (downloads a file named tsginfo.exe) | Windows XP (downloads a file named SysInfo.exe)

Stop Error 0x0000007B INACCESSIBLE_BOOT_DEVICE after PC was Ghosted

789 Views 1 Reply 2 Participants Last post by Toddles18, Jan 22, 2003

PB1856

Discussion Starter · Jan 22, 2003

Hi guys, I have an issue with a PC I am cloning using Ghost 7.5 I have done the research and it appears that I am getting the BSOD and stop error when Win2k is booting up for the first time due to drivers not being loaded for the SCSI Adapter(Adaptec SCSI Card 29160N).

I used sysprep on the source PC and haven't had any problems with the several other models of PCs that I have cloned, until I got to this particular SCSI Adapter.

After this happened, I went back and tried to include the drivers for the SCSI card in sysprep, but I never did modify the sysprep.inf file with the Pnp ID for this particular SCSI adapter. So the rebuild failed again and I assume this is why.

So my question is, does anyone know how to obtain the PnP ID information for this card that I need to include with the sysprep.inf and anything else you can think of that I am not doing right? Thanks!!

Save

Status: Not open for further replies.

1 - 2 of 2 Posts

Toddles18

· #2 · Jan 22, 2003

Personally I'd just install w2k overtop of what you already cloned into there. The programs are all already there, this way it will get the right driver and everything will be there. imho

Save

1 - 2 of 2 Posts

Status: Not open for further replies.

Top Contributors this Month