Tech Support Guy banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
158 Posts
Discussion Starter · #1 ·
eveytime i try to turn on my pc my monitor remains on standby. it seems but im not sure it's not booting. what could be wrong i've already checked all connections all are connected properly. i've already tried to change my videocard but its still not working i also tried to put in into the build in video it still doesnot work. i also used the jumpers to reset the cmos and cpu frequency. but else could be wrong? im using an ecs board sempron 2200 cpu 64mb v.card and 256 mb ddr mem. i've also tried to use other monitors. what else could be wrong.. thanks
 

·
Registered
Joined
·
7,826 Posts
Although I'm not sure what you did here:
" i also tried to put in into the build in video it still doesnot work"

since you've eliminated the video card and monitor, that leaves the power supply, RAM, motherboard and CPU. If you don't get the usual post beep, you'll have to eliminate the above items one at a time. It can also be helpful to disconnect all drives and remove all add in cards.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top