Tech Support Guy banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
Just had a new P4 motherboard installed: ECS P4M800PRO-M478 (V1.0) which replaced the original Celeron board that died suddenly. The new motherboard has 4 memory slots, 2 for DDR1 and 2 for DDR2. This board has a maximum 2GB capacity. The manual says you can't mix memory types. I read that to mean you can install up to 2GB in the DDR1 slots or up to 2 GB in the DDR2 slots but 2 slots will always be unused. Is this correct? The manual should make it clear but but to my mind it doesn't. Thanks for any clarification.
 

· Registered
Joined
·
10,313 Posts
SOCALKEN said:
I read that to mean you can install up to 2GB in the DDR1 slots or up to 2 GB in the DDR2 slots but 2 slots will always be unused. Is this correct?
Yes . . that is correct . . while the board can use either types, it cannot use both.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top