Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
When I switch computer on, A scandisk starts & then stops on 27percent then the following message appears--- An internal stack overflow has caused this session to be halted. Change the stacks setting in your config.sys file and then try again. I would greatly appreciate ANY help at all in curing the above problem. R.S.V.P. Mick.
 

·
Registered
Joined
·
2,218 Posts
I suggest that you try to reboot & as it starts to bootup hold the shift key down & let it open in safe mode... let the scandisk run.... all the way if it will...
 

·
Registered
Joined
·
2,218 Posts
I suggest that you try to reboot & as it starts to bootup hold the shift key down & let it open in safe mode... let the scandisk run.... all the way if it will...


Go do that now
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top