Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have an ATA100(ATX) power supply in a new P4 computer, but the power doesn't start itself, the board or drives. on 20 pin plug, pin14 supplies voltage to switch. which pin puts the power back to the supply to power it?
Thanks
 

·
Registered
Joined
·
21,334 Posts
Look at the back of the case and on the power supply there is a voltage selection switch. Make sure it's set to 110 for US applications.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top