Tech Support Guy banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Windows 98 hangs on boot screen at plug and play then when you reboot again it take you into config screen. Does this mean that the plug and play is disabled and need to be enabled. How concerned should I be in here I'm afraid I could mess things up. Then it asks for you to choose F10 and select yes to save changes!. OH BOY!
 

· Registered
Joined
·
3,372 Posts
d.a.,

You could mess things up, but you won't if you don't mess with what you don't know about.

And if you DO change something and get scared, then DO NOT SAVE. If you exit without saving, then 'No Harm, No Foul'.

At this point, I'm not sure what the problem is, but LOOK through the BIOS...it will be a good learning experience...and when you find the entry that says, "PnP Op/Sys installed" it should say Yes. Win 98 is a PnP Op/Sys.

One unanswered question on my mind is when did this start to happen and what did you do or change JUST BEFORE it began?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top