Tech Support Guy banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Whne I am using the Print studio of the subject software and try to print CD Label or card, once I have identified the model, it doesn't want to go to the next phase (paper selection) so I have to close it down. Everything else is fine. Any idea what can be the problem! I try to re-install but always have the same problem. Any help will be appreciated.

Yves
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top