Tech Support Guy banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Okay I kind of have a complicated setup.

I have a wired Linksys router (BEFSR41) and a wireless-G linksys router (WRT54G). I have 3 PCs I'm trying to network, all running Windows XP. PC-1 and my cable modem is connected to the wired router. I have a cable from the wired router to the wireless routers Internet port. PC-2 is connected to the wireless router via a cable. PC-3 is connected wirelessly to the router. The wireless router is setup as gateway (set in firmware config) and DHCP server disabled (tried turning gateway and DHCP options on and off). All three computers can access the internet but only PC-2 and PC-3 can access each other. Anyone have any ideas?

Thanks.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
How do you create a static route? I looked in the configuration and found where I could set up a static route but it asked for
Destination LAN IP: . . .
Subnet Mask: . . .
Default Gateway: . . .
Interface:

Never created a static route before if you could explain what routes I need to create I think I can figure it out.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top