Tech Support Guy banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
i ran this command :

/usr/sbin/sconadm register -N // This disable the solaris registry

a) How i'll enable solaris registry ?
After this command , i ran <init 6> reboot the system ,but no able to login to GUImode .
am just getting command line mode for Login .

b) How i'll get my GUI mode back and Registry diaable means not able to Login through GUI mode??:confused:

please provide the solution for that.....
 

·
Registered
Joined
·
94 Posts
Hmm... I apologize, I cannot help.

If you register here: http://forums.oracle.com/forums/forum.jspa?forumID=1015
And post the questions again, I would presume someone could assist you.

If there is a solution, please mark this as solved, and link to the topic on the other forum.

Cheers

*hopes the mods don't mind me suggesting another forum*
 

·
Super Moderator
Joined
·
82,234 Posts
*hopes the mods don't mind me suggesting another forum*
There was also a Report asking the same. I cannot give a general answer covering all cases, but in this case it is fine. After 3 days no Solaris experienced person has replied and I doubt there is much Solaris experience or knowledge among members of this forum.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top