Tech Support Guy banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
hi. I just bought a chaintech motherboard with nforce and an amd athlon xp processor with a 512mb kingston memory card and a g-force video card. After setting up with minimal hardware I still cant get a picture. I tried changing video cards and using different monitors and still nothing
 

·
Registered
Joined
·
4,168 Posts
Check the clear cmos jumper first to make sure it is not in the clear position. Some boards are sent with the jumper set to clear. Also you could clear the cmos by moving it to clear with the jumper for a minute or so. This will set it to default.

If The above does nothing, you may have a standoff shorting the board to ground. I would remove the board and set it on a piece of cardboard and hook it up with bare minimum and see if it boots.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top