1. Hello , my name is austin and I am attempting to get my nintendo switch oled mod chip fully Functioning.
2. My Main problem is the nintendo os is booting up normally and I'm not getting the no sd card messages.
3. The model number for my oled nintendo switch is xtw10006165177 the mod chip in use is the hwfly oled.
4. I'm really not not quite sure where to start on providing information. So i'm just going to start writing out everything that I currently know about my Situation.
5. As far as I know the modship is installed correctly. And everything is fully functional. I have checked all of my connections. six+ times Before Beginning putting everything back together. After Experiencing these problems I took off. The heat sink and checked again and was still getting the correct ratings.
6. The Multimeter is putting out the correct readings for what it is expected. To be To the best of my Knowledge.
7.I believe my problem is I do not have the correct firmware for the mod chip. I'm currently attempting to use. The picofly firmware fw_2.73.uf2 It's the only firmware I can find. I've been looking for a few days for the correct firmware. For the hwfly oled mod chip.
8.the mod chip is flashing blue 1x and yellow 12x times If anyone have as any thoughts on what might be happening are knows where to get the correct firmware I would be overjoyed because i've been working on this for a few days and have been stuck.
2. My Main problem is the nintendo os is booting up normally and I'm not getting the no sd card messages.
3. The model number for my oled nintendo switch is xtw10006165177 the mod chip in use is the hwfly oled.
4. I'm really not not quite sure where to start on providing information. So i'm just going to start writing out everything that I currently know about my Situation.
5. As far as I know the modship is installed correctly. And everything is fully functional. I have checked all of my connections. six+ times Before Beginning putting everything back together. After Experiencing these problems I took off. The heat sink and checked again and was still getting the correct ratings.
6. The Multimeter is putting out the correct readings for what it is expected. To be To the best of my Knowledge.
7.I believe my problem is I do not have the correct firmware for the mod chip. I'm currently attempting to use. The picofly firmware fw_2.73.uf2 It's the only firmware I can find. I've been looking for a few days for the correct firmware. For the hwfly oled mod chip.
8.the mod chip is flashing blue 1x and yellow 12x times If anyone have as any thoughts on what might be happening are knows where to get the correct firmware I would be overjoyed because i've been working on this for a few days and have been stuck.