Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
I have an NT server that has an HP 4050 three-tray printer set up on it. (The 4050 printer is attached to a print server on the LAN) When I go to the NT server to adjust the printer properties so that the printer will print to tray tree instead of tray two and click OK, the server does not remember the settings. So when I go back into the printer properties the configuration is still set up to print to tray 2. Does anyone have any suggestions I can try out? I already tried re-installing the driver for the printer.
 

·
Registered
Joined
·
2,323 Posts
Have you check the defaults on the front control panel of the printer? If the printer thinks that there is not the correct paper in tray two, then it will go to the next tray that it thinks has the correct paper.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top