Tech Support Guy banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Hi,

I have to face a problem with my hard disk.My computer worked well yesterday and while I was using nero for copying one file to CD,my computer hanged.So I restarted it again.But windows xp cannot load and I got boot disk failure error.So,I tried to boot from CD.Windows setup CD start normally and it cannot continue after a while and I got this error stop:c0000221 unknown Hare Error/SystemRoot/System 32/ntdll.dll.I am sure that my CD is good.
So I restart my computer and checked my hard disk at bios setup.There,my drive is not detected.I have checked my jumper setting and cable setting, but, bios setup does not know my disk.I have checked my hard disk at another good computer ,but at this computer ,my drive is not detected.
I think that all my bios setup setting for my hard disk is correct .I have set my hard disk to auto at setup.I need to say one thing that I have heard strange noice from my disk when I restart my computer.I think that my drive is physically damage.Is it right or not?I would like to know that how can I test to my disk that it is damaged or not and how can I recover my data if it is physically damaged.

I really appreciate to your help.

Yin Minn Pa Pa
 

·
Registered
Joined
·
17,584 Posts
It sounds like the controller section of your hard drive is dead, as two separate PC's will not detect it as a hard drive any more, based on your description above.

Therefore, assuming that to be the case (and your tests do suggest that is the case) then you cannot recover the data.

You really need to get a professional data recovery company to quote on recovering the data. It will not be cheap, assuming it is even possible.

The disk maker should have some software available on their website for diagnostic use, but as the PC does not even recognise the drive in the BIOS, there will be no way to use the software, as it must be able to access the drive.

It would really help a lot if you could break up your post into paragraphs though, it is very hard to read and comprehend as a solid block of text. It makes it easy to miss the vital details needed to be ble to help.
 

·
Registered
Joined
·
5,855 Posts
Unless you REALLY need your data and have the money, you'll need to pay a recovery service to retrieve the data. Looking about $1500~3000. They charge by the KB.

Or know what you're doing and buy an exact HD and replace the system board, which is ... tricky... ( I never done it )


if the drive is SPINNING but no BIOS (double check the cables again, but doubt it) and by Strange noise.... something simular to fingernails on a chalk board (scraping metal) - if so, then your heads crashed and the discs have physical damage. I'd say, 100% drive is dead... :(
 

·
Retired Moderator
Joined
·
106,726 Posts
FWIW, I've had about a 50% success rate replacing the PCB on a dead drive with a working one. If you manage to find one close enough in function, it will sometimes solve the issue. It depends on the drive how close you have to match it, I've had some Maxtor drives that I was able to take the board from a different size drive (same basic model) and recover the data. I've had other drives that I used the same exact board, but only a different EC level, and it failed.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top