Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
okay, so I built a computer for my friend (amd xp 3000+, 512mb, 64mb video card)

and at first we didn't use any thermal paste, so we were getting temperatures around 80C.

then we did apply some thermal paste, and that dropped the temperatures to 50-60C.

so now, everything is good, however we realized that the computer is underclocked and running slow (running at 1 - 1.4 ghz).

so we decided to bring that back up to 2.0 ghz however the temparatures went higher than 70C

so then we stoped that, and bought a larger heatsink. at first my friend put the heatsink on the wrong way, (backwards) and turned on the computer to realize he was getting temps at 70+ again.

we then changed the heat sink around the proper way, yet, the computer now will turn on with power and everything running, however we aren't seeing anything on the monitor.

keep in mind that everything was working great before.... and the video card works for sure as we tested it, and there is no problem with the monitor.

everything is getting power and everything turns on (fans).

why aren't I seeing anything?

thanks
 

·
Registered
Joined
·
809 Posts
and at first we didn't use any thermal paste, so we were getting temperatures around 80C.

then we did apply some thermal paste, and that dropped the temperatures to 50-60C.

so now, everything is good, however we realized that the computer is underclocked and running slow (running at 1 - 1.4 ghz).

so we decided to bring that back up to 2.0 ghz however the temparatures went higher than 70C

so then we stoped that, and bought a larger heatsink. at first my friend put the heatsink on the wrong way, (backwards) and turned on the computer to realize he was getting temps at 70+ again.
I think you mightve fried the CPU sadly, 80 degrees C is beyond most CPU's max temp. And the fact that you had the PC on different occasions when it was running to hot might've fried it, after all it only takes fractions of a second to fry modern proccessors
 

·
Registered
Joined
·
3,370 Posts
What did you do exactly to bring the Processor's speed up? Did you push up the FSB??? If you exceeded the recommended Bus Speed, you may have caused a problem with the PCI Bus (Video Card) from working properly.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top