When i turn on the screen, the screen shows the logo of the monitor. And then it says no signalHi and welcome to TSG,
Is there nothing at all on the screen, even just after switching on ? How do you know the display 'works fine' ?
I tried that and it did the same thing.Try resetting the Bios, remove the power cord from the PSU first.
Usually there is a jumper on the motherboard to do it, if not remove the Cmos battery for a few minutes.
That should make it use the onboard graphics again.
If it doesn't help what make and model motherboard is it ?
Already have. Its the right input and everything. I even replaced the hdmi, and switched to a different screen just to make sure.All I can think off is to check all cables are connected properly to the motherboard, also check the graphics cable of course.
On the monitor does it show which connection is in use, like VGA, HDMI etc ? If it does make sure it's the correct one.
PSU is smart series thermaltake SP500AH2NKWMaybe you could get an adapter cable so you can power the Graphics card properly.
What make and model PSU is it ?
Yes. I used my pcs built in graphics for months before. Would putting the new card back in with the adapter fix it?Your components should work together, the PSU is not bad and the Graphics card is rated at just 75 Watts so there should be plenty of power to drive it. You will need an adapter cable though.
Were you using the built-in graphics of the Ryzen 3200G successfully before you tried the new graphics card ?
I can't say for sure, it depends on whether there is some sort of problem with the motherboard or cpu, I think it's your best bet now though.Yes. I used my pcs built in graphics for months before. Would putting the new card back in with the adapter fix it?
What kind of adapter should i useYes. I used my pcs built in graphics for months before. Would putting the new card back in with the adapter fix it?
