Tech Support Guy banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just upgraded the bios on this board from F11 to F19.

With F11 bios I was able to run 2 1gb sticks of Corsair Value Select DDR400 (PC3200)
ram if I boosted the DDR voltage to 2.6v. I've set the new bios to 2.7v and still can't get it to post with 2gb installed.

Now with the new F19 bios the system won't post with 2gb installed. Gives me a DRAM error post code (one long beep repeating).

If I reduce the memory to just one stick...1gb. System boots and runs.

Any ideas? Don't know what to do with memory timings as this is a new game for me.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top