Tech Support Guy banner
Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a very interesting situation. I notice that on my device manager I cant find my cd rom even when is working, under hard disk controllers I have exclamation marks for the primary IDE controller (fifo) and secondary ide controller (fifo). If I remove the
via bus master pci ide controller and reboot to make windows 98se to reinstall them, after reboot the situation persist. When in safe mode I can see my cd rom and there are no exclamation marks. How can I resolve this? I need to install a dvd ram with an scsi but the scsi shows exclamation mark also. I think has to do with the above concern. Need help, Please as soon as possible
 

·
Registered
Joined
·
3,178 Posts
Hi, Welcome to the Forum.

When did this problem first occur? In Device Manager, does it say "you need to re-load the drivers for this device", under the Drivers tab of the controller? Or is the problem a resource conflict? Instead of just removing them and restarting, have you tried re-installing the drivers through Device Manager? Also, what do you have running at startup (and in your config.sys and autoexec.bat)?

Did you try removing your SCSI card?
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Hi Columbo. I notice this problem when I try to install a adaptec 2930 pci scsi for a dvd ram. When I click over either the primary or sec the message is "device is either not present or working properly or some driver is missing. I reinstall the drivers and try with other drivers presented by windows. The problem remains. I removed the scsi card, his drivers and remove the scsi from device manager. Regarding start up , config and autoexec. What do you mean or what should I look for? Thanks for your response.
Appreciate that!

Spectrum
 

·
Registered
Joined
·
3,178 Posts
Hi Spectrum,

Did removing the SCSI card fix the problem, then? Go to Start, then Run, then type in msconfig. Click on "Selective Start-up", and take the checkmarks off of config.sys and autoexec.bat. Then click OK, save the changes, and reboot your machine.
Does it work now?
If yes, then the problem is with your config.sys or autoexec.bat.
If not, then we'll have to try something else.
Try this, and let us know what happens.

:)
 

·
Registered
Joined
·
3,178 Posts
Hey,

Go ahead and do that selective startup. It won't hurt anything, and could be helpful in diagnosing your problem.

:)
 

·
Registered
Joined
·
6,832 Posts
Do you have the latest 4 in 1 driver update from Via?
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #8 ·
Hi Columbo! Thank you for your support. I could solve the problem yesterday. It was a pcmcia drive with dos drivers. Windows did work with them but dos confined the pcmcia drive as D. When I try to install a DVD ram with SCSI card, windows was having conflicts to organize and set the additional drive letters. As the cd rom was in a motherboard ide connection, there was no conflict before. I went to dos and locate on dir the drivers. When I delete them , windows went free as a butterfly. Just add this to your handbook and make it run. If a dos driver consign drive letters in dos. when installing additional drives you will get some exclamation marks on device manager as a conflict result

thanks for your support. You was the only one to help and I appreciate it.:D
 

·
Registered
Joined
·
3,178 Posts
Craziness.:confused:

Always glad to help out.

Best of luck in the future!



:D
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top