Tech Support Guy banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,
I have a W2K box w/ SP2. I had a DUN icon established for mindspring. Worked fine until I installed TCP/IP printing. Now When I dial out, it dials, logs onto the network, tries to register on the network then then I get the following error:
"Error 720: The connection attempt failed because your computer and the remote computer could not agree on PPP control protocols."
I have the DUN set up with TCP/IP, obtain IP.. and the rest of the defaults. I pulled up a couple of articles from the MS Knowledge Base stating it had something to to do with not having Netbios interface installed or I needed to verify the bindings of the Netbios are enabled and properly established with the NDISWAN drivers? Both of those options, I can not find the binding section to save my life, nor can I see where to install the Netbios service? Any advice on this problem would be appreciated.
Sincerely,
Roofus
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top