Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
9,467 Posts
Discussion Starter · #1 ·
Using Drive Image Pro, versions 4 and 5.

When I boot into Drive Image using either version, I get an error message that "EZ-Drive is present but not running". The error message further reports that I should remove the drive image diskette, reboot and hold down the Ctrl key and when prompted, select to boot from A drive then insert the Drive Image diskette and continue.

EZ-Drive has never been on this hard disk; however, just to be sure, I downloaded and ran a utility that completely erases the drive and returns it to the same condition as it was when it was new. I then re-FDisked the drive, reformatted and then tried again.

The result was the same.

PowerQuest has nothing on their site about this.

Any ideas?
 

·
Registered
Joined
·
9,467 Posts
Discussion Starter · #4 ·
For the benefit of those who might have the same or a similar problem, I found this at PowerQuest. It addresses the problem; but, I haven't had a chance to try it yet. I have already restored the drive by manually reinstalling all the programs one-by-one and then restoring the data from a backup that is brought up to current every two hours.

There is only one critical folder that is left in the Drive Image backup that must be restored; however, Drive Image does not allow the restoration of a single folder, only entire partitions, so I'll have to work out something on that later.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top