Tech Support Guy banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Bought the Performa 600 mHz processor upgrade...installed it and... my floppy was dead...software for the new CPU is on floppy... download software at Evergreen site requires a floppy drive..worse: bought a new floppy and that won't work.
Evergreen Tech Support is silent to e-mail.

Any ideas about software to allow me to do a self-tweek?


Thanks, mandius
 

·
Registered
Joined
·
12,041 Posts
check the cable and power plug going to floppy, make sure it is tight and connected with red stripe to pin 1.

Check in bios, make sure floppy is enabled and set to 1.44m

Good chance you just knocked the cable loose
 

·
Registered
Joined
·
7,530 Posts
Also, make sure any pins weren't pushed in any time you've adjusted the cable. I did that once. :D Just putting it out there...
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top