Please click the link below for your operating system to download the TSG SysInfo Utility. Click on "Save File" then double-click the file to run it. Copy and paste the report in your initial post. Windows 7 and later (downloads a file named tsginfo.exe) | Windows XP (downloads a file named SysInfo.exe)

Copying Old Harddrive

835 Views 5 Replies 4 Participants Last post by Rich-M, Dec 29, 2006

LyrradMelon

Discussion Starter · Dec 28, 2006

I have an old hard drive with windows 95 on it that will only launch in safe mode. I need to copy some data off it but i cant connect it and my new hard drive (running windows XP) to the computer at the same time because the computer gets confused with which one to launch. The easiest would be if i could just connect the two, so if there is a way to do that please let me know.
I have tried running a few linux live distros but because they are live, I can't copy data off of the drives. Thanks for any help that you have to offer.

Save

Status: Not open for further replies.

1 - 1 of 6 Posts

crjdriver

· #4 · Dec 29, 2006

It is probably because you had both devices set as the master device. When you have two devices on a single ide channel, one must be the master and one the slave. This is done with jumpers either M/S or CS [cable select]

Save

1 - 1 of 6 Posts

Status: Not open for further replies.

Top Contributors this Month