Tech Support Guy banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a sagem 3304 wifi modem router provided by the telecoms company. it has a limited wifi range and in my experience of wifi it also has frequent dropouts/connection problems. we connect the desktop pc to it by ethernet and that's just fine.

we also were given (by a 3rd party) a belkin n1 wireless router (the model without modem) and would like to try it out to be the wifi router. The idea is to connect it by ethernet to the sagem and place it in a more central part of the property. I reckon about 15m of ethernet cable. we would disable the wifi on the sagem. had we been given the belkin model with internal modem, this would not be an issue and we would not need to use the sagem at all - that is not meant to sound ungrateful!!

can anyone see any pitfalls with this? or if it is do-able, any recommendations re:configs?

I have found another post loosely related to using 2 routers however it doesn't really address this specifically:
http://forums.techguy.org/networking/715999-using-2-routers-same-time.html
 

·
Retired Moderator
Joined
·
106,726 Posts
Connecting two (or more) SOHO broadband routers together.

Note: The "primary" router can be an actual router, a software gateway like Microsoft Internet Connection Sharing, or a server connection that has the capability to supply more than one IP address using DHCP server capability. No changes are made to the primary "router" configuration.

Configure the IP address of the secondary router(s) to be in the same subnet as the primary router, but out of the range of the DHCP server in the primary router. For instance DHCP server addresses 192.168.0.2 through 192.168.0.100, I'd assign the secondary router 192.168.0.254 as it's IP address, 192.168.0.253 for another router, etc.

Note: Do this first, as you will have to reboot the computer to connect to the router again for the remaining changes.

Disable the DHCP server in the secondary router.

Setup the wireless section just the way you would if it was the primary router, channels, encryption, etc.

Connect from the primary router's LAN port to one of the LAN ports on the secondary router. If there is no uplink port and neither of the routers have auto-sensing ports, use a cross-over cable. Leave the WAN port unconnected!

This procedure bypasses the routing function (NAT layer) and configures the router as a switch (or wireless access point for wireless routers).
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top