Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
220 Posts
Discussion Starter · #1 ·
:eek:Dear Friends;

We have a machine which have two old Industrial PCs with WNT installed. PC 1 is master which send data to PC 2 slave. The two PCs communicate through 3Com communication cards installed in each PC which connected through a Coaxial cable. Now we have been facing a problem that both PCs are not being communicated. We tested the cable, connectors and 3Com cards and found ok. Some time it happens that if we shutdown the PCs and start after half an hour, we found communication ok but after five minutes communication again fails. So I need help from our experts in this forum how I can fix that problem.

The detail of communication card is;
Chip Details,
Parallel Tasking II Performance
3Com 40 0456 004
9853T-19276435
LUCENT 40-045644
With COAXIAL cable Connector (Old Type 10Mb/Sec)
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top