Please click the link below for your operating system to download the TSG SysInfo Utility. Click on "Save File" then double-click the file to run it. Copy and paste the report in your initial post. Windows 7 and later (downloads a file named tsginfo.exe) | Windows XP (downloads a file named SysInfo.exe)

Caught in a loop

917 Views 1 Reply 2 Participants Last post by Melissa, Nov 16, 2001

Dave9715

Discussion Starter · Nov 16, 2001

Hello all Here is my trouble

Last night I upgraded my pc from ME to XP the upgrade went fine. So I was installing a Symantec's PC anywhere and after the install I rebooted the system and it goes through the BIOS and just before you get to the windows xp screen it says " No Emulation" Boot from ATAPI cd- rom........ it then trys to open windows and crashes back to the boot screen. this happens over and over and over when finally I have to shut it off. Any Ideas other than a format C: command ???????

Save

Status: Not open for further replies.

1 - 2 of 2 Posts

Melissa

· #2 · Nov 16, 2001

Before your PC crashes back to the boot screen, are you given the option to prompt the Last known good configuration? If so try that.

Save

1 - 2 of 2 Posts

Status: Not open for further replies.

Top Contributors this Month