Tech Support Guy banner
Status
Not open for further replies.
1 - 11 of 11 Posts

· Registered
Joined
·
1,003 Posts
Discussion Starter · #1 ·
arrghh!! i am having so much trouble with the airflow in my case.
actually, it all started with the temp of my cpu, which runs at 39-42 under an average load according to both mbm5 and bios (like right now its at 40). the case temp is 30, almost always 10 below the cpu temp. i have a good copper based heatsink w/ aluminum fins- and the fan is supposed to push 39 cfm as the max airflow, @ 3000 rpms.
after replacing the cpu fan w/ several different types and there wasn't any change, i decided maybe it was the airflow in the case. i have a 120mm fan, unsure of the brand, in the front of my case as the intake, and then the psu is dual fan equipped, and then there is a rear 80mm ADDA fan blowing outwards, and then one side panel fan right smack in the middle of the window.
does anyone see any obvious mistakes i may be making here?
 

· Registered
Joined
·
12,709 Posts
First Name -
Jay
Your airflow is probably fine. THough if your wiringis just hanging loose and all over the place, I would tie it up carefully so that is neatly bundled and away from cards and parts as much as possible. I tie my round IDE cables as much as possible to the side of the HDD mounts And Power supply wires are bundled as much as possible also. Though this doesnt necessarily increase air flow it does make it less turbulent and more free flowing.

39c is not too high under moderate load. So you dont have much to worry about.
 

· Registered
Joined
·
1,003 Posts
Discussion Starter · #3 ·
i don't want my case to sound like an airplane!!! it's not like i have it on the floor or in a cabinet type thing, its right in my face.
ok- here is a pic of the inside... please don't scold me about the wires, i know its a mess in there!
http://www.geocities.com/[email protected]/whatamess.htm
 

· Registered
Joined
·
1,003 Posts
Discussion Starter · #4 ·
hey- wait a second, what does A weighted mean? and how does that make it so quiet? 45dBA @ 105 cfm is quiet...
 

· Registered
Joined
·
12,709 Posts
First Name -
Jay
Actually your case looks pretty clean inside to me. Either that or I AM really blind. And like I said under moderate load that temp is not too bad at all. Try checking the idle temp. and see what it is.
 

· Registered
Joined
·
1,826 Posts
Everything looks fine to me. There's only so much you can do with all those wires and all.

What's the real problem here? Is it just too loud with all those fans buzzing away?

Your temps look fine.
 

· Retired Moderator
Joined
·
110,551 Posts
I think you're trying to solve a problem that you don't have. Both of my AMD systems processors run 8-10 degrees higher than the case temperatures, and I don't give it a second thought.
 

· Premium Member
Joined
·
52,999 Posts
First Name -
Rob
You don't have a problem; your temps are fine. 39-42 degrees are well within spec. Thats the same temps I run at, although my mobo temperature is generally in the low 20's which is similar to my room temp.
 

· Registered
Joined
·
511 Posts
As the other guys have said you dont have a problem with the temps.
I did notice a space for another 80mm fan at the back of the case. If you put a fan ther extracting air, then it would increase the airflow a bit.
There is a company called Vantec that make really quite, almost silent fans if your looking to keep noise to a low.
 

· Registered
Joined
·
12,709 Posts
First Name -
Jay
KerriAnn, I dont think you are having any problems at all. You have done a great job of keeping your case neat and tidy. You seem to have plenty of air flow and cooling. And the temps are actually good. I would stop worrying and enjoy what you have built. And you appear to have room for future upgrades you did good.

How about a picture of the finished product (the whole thing).
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top