Tech Support Guy banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I try to get an old 486 DX4 running. Every time I want to boot from floppy disk it hangs up (while showing "loading MS Dos" etc.). There is a Dos version of Windows 95 installed and you can write and read from the floppy disk. So I tried to install Win 95 using Laplink. But when the Setup restarted the Computer it hang up again. It seems to be a BIOS settings problem because I replaced the Harddisk and the floppy drive and it was still the same. Has anyone an idea, what else I could try? (Perhaps it has to do with the PCI Graphics Card, because the last message on the screen is: PCI device is listening... and then it shows the Port settings and so on)
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
I have Win95 on CD-ROM. That's why I had to use Laplink. The problem now is, that it hangs up all the time (before I installed Win95 it hung up only when there was a boot disk in the floppy drive). I also tried to change the slot of the PCI- Graphics Card but that didn't change anything. The strange thing is, that the Computer works (or better worked, before I tried to install Win95) correct, you can read and write from disk and so on, it has just problems, when it boots from floppy disk or reboots after you have run a setup program... I wonder if the motherboard is damaged...
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
No, not on DOS 6.22, that's the problem. It is a Win95 Dos Version. I tried to install Dos 6.22 but if you want to do that, you have to reboot and there we are back again...
The next thing I tried was to install Win 3.11 and try to upgrade it to Win95, but Win 3.11 is not compatible with the Dos version...
As I have no CD-Rom under Dos, I tried to use Laplink to install it (I used it as an "external CD-ROM-Drive", if you want...). But anyway, if I would have installed it from an external CD-ROM Drive it would have been the same: When the setup is finished, the PC reboots and that's where it hangs up all the time.
 

·
Retired Administrator
Joined
·
103,703 Posts
Hi LAN, I'm not sure if everyone is able to follow here....

What do you mean by windows 95 dos version????

And when you say you have no cdrom under dos.....have you tried booting with a windows bootable floppy disk that has cdrom support?

When you say it hangs, does windows eventually load? Or just come to a standstill?
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top