Please click the link below for your operating system to download the TSG SysInfo Utility. Click on "Save File" then double-click the file to run it. Copy and paste the report in your initial post. Windows 7 and later (downloads a file named tsginfo.exe) | Windows XP (downloads a file named SysInfo.exe)

Boot from sata card

1109 Views 6 Replies 3 Participants Last post by Wet Chicken, Apr 7, 2004

Audioman1

Discussion Starter · Apr 7, 2004

I just got a W.D. Raptor 10.000 rpm sata drive to install my O/S on, and then found out I didn't have a sata plug on my board so i sent for a SATA card and wire, Is there a way to set up my PC to boot from the Raptor Drive? I have Awards bio's The board does support SATA drives.

ABS Awesome 3300
AMD Barton 2600
1280 mgs Ram
XP Home sp-1
- Gigabyte GA-7N400-L nForce2 Ultra400 Dual Channel DDR
- Albatron GeForce FX 5200 128MB DDR DVI/TV-out
- Leadtek "EXPERT" PCI TV/FM Tuner Card with Remote
- Creative Labs Sound Blaster Audigy 2 ZS 24-bit Plat.Pro. &
Logitech Z-680 5.1 Surround Speaker Set

Thank You

Save

Status: Not open for further replies.

1 - 2 of 7 Posts

Wet Chicken

· #5 · Apr 7, 2004

It will see it as a SCSI card! Make sure all of your drivers are in order for the card first

Save

Wet Chicken

· #7 · Apr 7, 2004

You should set up the boot sequence as SCSI first. Sometimes CD Rom works too. If you have another SCSI card in the computer, most likely you'll need to turn it off.

Save

1 - 2 of 7 Posts

Status: Not open for further replies.

Top Contributors this Month