Tech Support Guy banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter · #1 ·
Everytime i power on the packard bell pc i must press
f2 to go to bios and press F5 to set it to default or
redetect the HD and then reboot back. Only then
will it boot to windows. Otherwise the system will
not boot to windows but prompt me to run setup.

I had checked the cmos jumper setting to correct and
had changed to a new battery but still the problems
persists. I had also try setting the HD to auto and
user still no go.

What else can i do?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top