Tech Support Guy banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hello,

Just purchased an 800 Mhz/100 Mhz Bus Celeron for my Abit BH6 motherboard. I have a 370 adapter and installed the cpu on it and replaced everything. But the cpu is not functioning. I know there is a row of dip switches and jumpers on the adapter and was wondering what config i may need to get the cpu up and running as there was no documentation with the adapter. I know with the latest bios update that my machine can handle the 800 Mhz/ 100Mhz FSB. Can anyone help me out?

Thanks!
 

· Registered
Joined
·
12,105 Posts
First is the adapter fcpga compliant, older adapter don't work with coppermine chips.

If it is I would suggest setting the adapter to auto and using the bios to control the chip with softmenu. Depends on your specific adapter, there all a little different.

I used an adapter on an abit bf6 with a celeron 366 without any problem. I also know that all abit motherboards will work with the slotkey adapters.
 

· Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
Hi there,

I need the manual to go with my Abit Slotket Adapter. Went to Abit site and the link is either dead or was never working!!! If anyone can help me out as i have to know the jumper settings for FSB etc....

Thx...
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top